In the majority of cases, most people spend quite a lot of money purchasing their forklift. Therefore, it is extremely essential to take good care of it in order to protect your investment well into the long run. It is a good idea to know the procedures which are carried out in the care and maintenance of this piece of machinery.
Among the best ways to tell how good the engine is running is by starting the lift truck up and listening closely to see how it runs. For instance, if there are any knocks or misses, the machine is defective and this must raise some issues. What's more listen closely for any squealing noise which come from the belts because these sounds will provide you with a wealth of information.
When performing maintenance, some of the main components you would need to pay attention to comprise the horn, safety warning devices, the overhead guard, the lights and the gauges. Any faulty components or burnt out light bulbs must be replaced as soon as they are noticed. It is also essential to inspect the wiring.
The battery compartment terminals must be cleaned after the above parts have been inspected carefully. If the terminals are not clean, be sure to clean them properly. Every cell of the battery must be inspected in order to ensure the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machinery and then change the filters. The hydraulic filter, the transmission filter and the fuel filters should be frequently replaced. Before fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
After the oil change is done and the filters have been replaced, a visual inspection of the drive axle has to be performed. If there is a grease fitting on the axle make certain to apply some grease. Inspect the engine belts for any cracks or frays. If you find any, fix the issue accordingly. Next, inspect each and every other part of the machine like the wheels. If any type of fault or concern is detected, be sure to deal with it immediately in order to make certain the machine is running at its safest and optimum levels.